|
You can't go wrong. This is truly a must have for the Bosch table saw. Sturdy construction and easy to use.
Make sure you install the short rod on the right and the long rod on the left and it will work fine.The mounts are also slotted for adjustment.I mounted my rods on the wrong side originaly and hit the red handle mentioned.Three months later I took the time to examine it and saw the rods are different sizes.I'm pretty sure I followed the instructions before but the rods were backwards regardless.
But I'm sure you can figure it out.Overall review: These were what I expected, fit my 4100 series Bosch worksite table saw, and were easy to install following the included instructions. This modification brought it very close to level, for just over $2 in washers at my local big box hardware store.I do say a few odd words here and there in the video (quarters when I meant washers, etc). Watch Video Here: http://www.amazon.com/review/R366E58EMMI59N There seem to be plenty of conflicting reviews on both the left side extension and the outfeed extension, and I've made this video to clear them up. Issues cleared up:- The front bar for the left side extension is short enough to not hit the red lever for the right side extension.- Both left side extension and outfeed extension come with a stop knob for securing the extensions either open or closed.- Both extensions sag just a little, which I fixed by placing a washer (approx 0.043 in thick) between the brace and the tablesaw for the _back_ bolt on each bracket.
The Bosch 4100 table saw could only be improved if this extension came in the box.I had no problems installing it and it works just like it should: as a second pair of hands to steady large sheets, posts, etc.
Still doesnt really allow you to rip whole sheet comfortably with mobil saw but after using Skil saw to cut them to a more manageable size these extensions really came in handy Really like both the rear outfeed and left feed extension, I bought them both after I had to rip a bunch of 3/4" 4'x8's.
|
